Back squats are a common strengthening exercise for knee and hip musculature. However, repetitive loaded movements like backs squats result in high patellofemoral joint loading and therefore may contribute to the development of common overuse injuries. Thus, it is important to understand how changing parameters such as squat depth or load influences patellofemoral loading. This study investigated differences in patellofemoral loading when experienced female lifters squatted to three depths (above parallel, parallel, and below parallel) and with three loads (unloaded, 50%, and 85% of depth-specific one repetition maximums). Patellofemoral joint reaction forces (pfJRF) and stresses (pfJS) were calculated from biomechanical models incorporating knee extensor moments (KEM) and joint angles. Peak KEMs displayed a depth-by-load interaction such that within each depth, as load increased so did peak KEM. However, within each load, the effects of depth were different. Peak pfJRF also increased with load and was higher at below parallel than above or parallel depths. Peak pfJS also displayed a depth-by-load interaction, increasing with load within a given depth, and being greatest at the below parallel depths within a given load. If patellofemoral joint loading is a concern, clinicians or coaches should carefully monitor the depth and load combinations being used. Highlights The barbell back squat is one of the most ubiquitous exercise for improving lower extremity strength. While several studies have been performed in males, the interactive effect of squat depth and load on patellofemoral joint kinetics remains relatively unstudied in female lifters. Patellofemoral joint kinetics in female lifters are influenced by both the depth of squat and load used, so if loading of the patellofemoral joint is a concern, clinicians or coaches should carefully monitor the depth and load combinations used in rehabilitation or training.
© Copyright 2021 European Journal of Sport Science. Wiley. Alle Rechte vorbehalten.